Honda S2000 Service Manual page 1069

sRs
SRS Indicator Circuit Troubleshooting (cont'd)
6. Disconnect SRS unit connector 18P connector (A)
from the SRS unit
23-56
7. Disconnect gauge assembly connector A (14P).
Connect a voltmeter between the No. 4 terminal of
gauge assembly connector A (14P) and body
ground. Turn the ignition switch ON (ll), and
measure voltage. There should be 0.5 V or less.
GAUGE ASSEMBLY CONNECTOR A {lirP)
ls the voltage as specified?
YES Faulty SRS unit; replace the SRS unit (see
page 23-75).r
NO Short to power in the PNK wire of dashboard
wire harness A or in the SRS main harness; replace
the faulty harness.l
Turn the ignition switch OFF. Check the No. 5 (7.5A)
Juse in the under-dash fuse/relay box,
ls the fuse blown?
YES Go to step 10.
NO Go to step 9.
8 ,
Wire side of female terminals