Cylinder Head Cover Installation - Honda S2000 Service Manual

44. Installthe throttle cable (see page 11-125), then
adjust the cable (see page 11-1241.
45. After installation. check that alltubes, hoses and
connectors are installed correctly.
46. After assembly, wait at least 30 minutes before
filling the engine with oil (see page 8-5).
47. Refillthe radiator with engine coolant. and bleed
air from the cooling system with the heater valve
open (see page 10-8).
48. Connect the negative battery cable first, then
connect the positive cable.
49. Inspectforfuel leaks. Turn the ignition switch ON
(ll) {do not operate the starter) so that the fuel pump
runs for about 2 seconds and pressurizes the fuel
line. Repeat this operation two or three times, then
check for fuel leakage at any point in the fuel line.
50. Perform the engine control module (ECM) idle learn
p r o c e d u r e ( s e e p a g e 1 1 - 1 0 0 ) .
5 1 . I n s p e c t t h e i d l e s p e e d ( s e e p a g e 1 1 - 1 0 0 ) .
5 2 . I n s p e c t t h e i g n i t i o n t i m i n g ( s e e p a g e 4 - 1 8 ) .
53. Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
54. Set the clock.
1 .
Cylinder Head Cover Installation
Install the head cover gasket in the groove of the
cylinder head cover.
Set the spark plug seal (A) on the spark plug tube.
lnstallthe cylinder head cover (B) on the cylinder
n e a d .
NOTE:
. Take care not to damage the spark plug seals
when installing the cylinder head cover.
. Visually inspect the spark plug seals for damage.
(cont'd)
6-53