Honda S2000 Service Manual page 410

Manual Transmission
Transmission Removal (cont'dl
Remove the five lower transmission mounting
bolts.
Place a floor jack under the front sub frame and the
engine mounting stiffener.
Remove the two center mounting bolts.
Loosen the four mounting bolts 75 mm (3.0 in.) as
s n o w n .
2 1 .
28.
29.
1 . 1
\ . - . . . - t
m m
) in.)
1 3 - 1 0
Lower the front subframe in until it touches the four
loosened mounting bolts.
Place the floor jack under the transmission, and
remove the three transmission rear mount bolts.
Lower the transmission. Disconnect the oick-uD
sensor connector (A), then remove the wire
h a r n e s s ( B ) f r o m t h e t r a n s m i s s i o n .