Honda S2000 Service Manual page 593

23.
24.
W a s h t h e k n u c k l e a n d h u b t h o r o u g h l y i n h i g h f l a s h
point solvent before reassembly.
Press a new wheel bearing (A) into the knuckle (B)
using the old bearing (C). a steel plate (D), the
specialtool, and a press, Place the wheel bearing
on the knuckle with the pack seal side {metal color)
facing inside. Be careful not to damage the sleeve
o f t h e D a c k s e a l .
I
B
2 5 . I n s t a l l t h e s n a p r i n g ( A ) s e c u r e l y i n t h e k n u c k l e ( B )
D
4.9 N.m 10.5 ksf.m. 3.6 lbf ft)
I n s t a l l t h e s p l a s h g u a r d { C ) , a n d t i g h t e n t h e s c r e w s
( D ) .
BLACK COLOR
2 7 .
Wash the spindle thoroughly in high flash point
solvent before reassembly,
I n s t a l l t h e h u b ( A ) o n t o t h e k n u c k l e { B ) u s i n g t h e
special tools and a hydraulic press. Take care not to
deform the splash guard.
2 9 . I n s t a l l t h e p u l s e r ( A ) .
28.
n-'.X./
\#
./ln*r.u^
e\'/
?"rlidi.-,
242 tbl.ftl
30. A p p l y a s m a l l a m o u n t o f e n g i n e o i l t o t h e s e a t i n g
s u r f a c e o f a n e w s p i n d l e n u t ( B ) . I n s t a l l t h e n u t , a n d
tighten it to the specified torque. Stake the nut
shoulder against the driveshaft with a drift.
I n s t a l l t h e h u b c a p ( C ) .
(cont'd)
1 8 - 1 5