I
Fenderwell Trim Replacement
NOTE:The steel core in the fenderwelltrim cannot be
restored to it original shape once it is bent. Replace the
fenderwelltrim when the steel core is bent.
1. Remove the fenderwell trim by pulling it out.
2. Installthe fenderwelltrim, and note these items:
. Clean the body bonding surlace with a sponge
dampened in alcohol.
. After cleaning, keep eil, grease and waterfrom
getting on the clean surface.
. Apply clear sealant in the groove of the trim at
the area indicated by the arrow.
. Scrape or wipe the excess sealant off with a soft
shop towel dampened in alcohol.
Sealant: Cemedine P/N 08712-0004, or equivalent
a
Rear Air Outlet Replacement
NOTE: Take care not to scratch the body.
1. Remove these items:
. Rear trim panel (see page 20-73)
. Rear bumper {see page 20-93)
Remove the rear air outlet as shown.
I n s t a l l t h e a i r o u t l e t i n t h e r e v e r s e o r d e r o f r e m o v a l ,
and note these items:
. Replace any damaged clips.
. Push the clip portions into place securely.
Fastener Locations
A > : C l i p . 2
(1.r4 -
x
REAR AIR OUTLET
2 .
?
20-107