B-Pillar Outer Weatherstrip Replacement; Drain Tank And Lower Drain Hose Replacement - Honda S2000 Service Manual

Gonvertible Top
B-Pillar Outer Weatherstrip
Replacement
NOTE:
. Take care notto scratch the body
. Use a clip remover. to remove the clips.
1. Remove the B-pillar outer weatherstrip as shown.
2. Installthe weatherstrip in the reverse order of
removal, and note these items:
. R e p l a c e a n y d a m a g e d c l i p s .
. lf the old weatherstrip isto be reinstalled, scrape
off all traces of old butyl t8pe, then clean the
weatherstrip surface with alcohol. Glue the new
butyl tape into position.
Fastgnsr Locations
A > : S c r e w , 1
B D : C l i p , 1
B.PILLAR OUTER
WEATHERSTRIP
BUTYLTAPE
T h i c k n e s s : 1 . 5
m m
(0.06 in.)
Width: 4 mm {0.16 in.)
C > : C l i p , l
20-52
Drain Tank and Lower Drain Hose
Replacement
NOTE:
. Take care not to scratch the body
. Take care not to drop the screw.
1. Remove the convenible top assembly (see page 20-
38).
2, Remove the drain tank and lower drain hose as
s h o w n .
3. Install in the reverse order of removal, and note
these items:
. Replace the clip if damaged.
. Make sure the lower drain hose is inserted to the
drain valve properly.
. Make sure the drain tank is connected to the
lower drain hose properly.
Fastener Locations
, 1
B > : C l i p , 1
A > : Screw
@
LOWER DRAIN
HOSE
-i
r \ '
,..1 :...-r...
DRAIN VALVE