Heater Valve Cable Adjustment - Honda S2000 Service Manual

Heater Valve Cable Adjustment
1 . From under the hood, open the cable clamp (A),
then disconnect the heater valve cable (B) from the
heater valve arm (C).
From under the dash, disconnect the heater valve
c a b l e h o u s i n g f r o m t h e c a b l e c l a m p ( A ) , a n d
disconnect the heater valve cable (B) from the air
m i x c o n t r o l l i n k a g e { C ) .
4 .
Set the temperature control dial on Max Cool with
t h e i g n i t i o n s w i t c h O N ( l l ) .
Attach the heater valve cable {B) to the air mix
control linkage (C) as shown above. Hold rhe end
of the heater valve cable housing against the stop
( D ) , t h e n s n a p t h e h e a t e r v a l v e c a b l e h o u s i n g i n t o
t h e c a b l e c l a m p ( A ) .
From under the hood, turn the heater valve arm (C)
to the fully closed position as shown, and hold it.
Attach the heater valve cable (B) to the heater valve
arm. and gently pull on the heater valve cable
housing to take up any slack, then install the heater
valve cable housing into the cable clamp {A).
21-43