Hood Release Handle Replacement; Hood Latch Replacement - Honda S2000 Service Manual

a
Hood Release Handle Replacement
NOTE: Take care not to bend the caore.
1. Remove the kick panel (see page 20-69).
2, Remove the hood release handle as shown,
3. Installthe handle in the reverse order of removal,
and note these items:
. lMake surethe hood openercable is connected
propefly.
' Make sure the hood opens properly.
Fa3tenor Locations
A ) : B o l t , 2
(JJ @
HOOD OPENER CABLE
6 x 1 . 0 m m
9.8 N.m {1.0 kgf.m,
7.2 tbt.ttl
HOOD RELEASE HANDLE
Hood Latch Replacement
NOTE: Take care not to bend the cable.
Replacement
1. Remove the air guide plate cover, then remove the
hood latch as shown.
2. lnstallthe latch in the reverse order of removal, and
note these ttems:
. Apply grease to the hood latch.
. Make sure the hood opener cable is connected
propefly.
. Adjustthe hood latch alignment {see step 3 on
page 20-94).
. Make sure the hood locks securely.
Fastener Locations
A > : B o l t , 3
B > : O i p , 3
@
5 x 1 . 0 m m
9.8 N.m
{1.0 kgt.m,
7.2 tbf.ttl
(cont'd)
20-111