Honda S2000 Service Manual page 1071

sRs
SRS Indicator Circuit Troubleshooting lcont'd)
7 . Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the driver's airbag connector (A),
passenger's airbag connector 1B), and both seat
belt tensioner 2P connectors (C).
23-58
9. Disconnectthe SRS unit 18P connector (A)from the
SRS unit.
1 0 .
1 1 .
Reconnect the battery negative cable.
Turn the ignition switch ON (ll), and wait for 30
seconds. Then turn the ignition switch OFF.
Check the No. 1 (10 A) fuse in the under-dash
fuse/relay box.
ls the tuse OK?
YES - Short to ground in the SRS uniU replace the
SRS unit (see page 23-75).1
NO Go to step 13.
Replace the No. I (10 A) fuse in the under-dash
fuse/relay box.
Disconnect the SRS main harness connector A (2P)
from the under-dash fuse/ralay box.
't2.
1 3 .
1 4 .