Power Mirrors
2 .
3 .
Power Mirror Actuator Replacement
' t .
Remove the power mirror from the door (see page
20-21).
Record the terminal locations and wire colors.
Cutthe wire harness with a wire cutter.
Carefully pull out the bottom edge of the mirror
holder by hand.
Separate the mirror holder from the actuator by
slowly pulling them apart.
22-106
7 .
6. Remove the screws and the actuator from the
h o u s r n g .
Rovte the wire harness of the new actuator through
the hole of the mirror housing, then install the new
actuator in the reverse order of removal.
lnsert the terminals into the connector in the
original arrangement as shown below.
Lsft and right
Terminal side o{ male terminals
Reassemble the mirror in the reverse order of
disassembly.
Be careful not to break the mirror holder when
reinstalling it to the actuator.
Operate the power mirror to check that the actuator
works smoothly.
8 .
9 .
'10.