sRs
DTC Troubleshooting lcont'd)
DTC 3-3: Short to Another Wire or Decreased
Resistance in Driver's Seat Belt Tensioner
Special Tools Required
. SRS inflator simulator 07SAZ-TB4011A
. SRS simulator lead C 07TM-S25011A
1. Erase the DTC memory (see page 23-19).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to steD 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting lntermittent Failures (see
page 23-19).
3. Turn the ignition switch OFF, then disconnectthe
battery negative cable, and wait for 3 minutes.
4, Disconnect the driver's seat belt tensioner 2P
connector from the SRS main harness (A).
Connect the SRS inflator simulator (2 Q connector)
a n d t h e s i m u l a t o r l e a d t o t h e S R S m a i n h a r n e s s .
rr^rt;am
23-40
6 .
Reconnect the battery negative cable.
Erase the DTC memory.
1 .
8. Read the DTC.
ls DTC 3-3 indicated?
YES Go to step 9.
NO Short in the driver's seat belttensioner;
replace the driver's seat belt (see page 23-4).t
9. Turn the ignition switch OFF, then disconnectthe
battery negative cable, and wait for 3 minutes,
{