Abs Modulator-Control Unit Removal And Installation - Honda S2000 Service Manual

ABS Modulator-Control Unit Removal and Installation
NOTE:
. Donotspill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off
immediately with water.
. Take care not to damage or deform the brake lines during removal and installation.
. T o p r e v e n t t h e b r a k e f l u i d f r o m f l o w i n g , p l u g a n d c o v e r t h e h o s e e n d s a n d j o i n t s w i t h a s h o p t o w e l o r e q u i v a l e n t
material.
Removal
1 . P u l l u o t h e l o c k ( B ) o f t h e A B S c o n t r o l u n i t 2 5 P c o n n e c t o r ( C ) , t h e n d i s c o n n e c t t h e c o n n e c t o r .
FLARE NUT
To righl-tront
To left-rear
To right-rear
To left-front
mm NUT
s.8 N m 11.0 kgf.m,7.2lbf.ftl
--G mm EOLT
---'
9.8 N.m 11.0 kcI m, 7.2lbf ft)
2. Disconnect the six brake lines.
3. Remove the two 6 mm nuts.
4. Remove the ABS modulator-control unit (A).
lnstallation
1. lnstall the ABS modulator-control unit, then tighten the two 6 mm nuts.
2, Alignthe connecting surface of the ABS control unit 25Pconnector.
3 . P u s h i n t h e l o c k o f t h e A B s c o n t r o l u n i t 2 5 P c o n n e c t o r u n t i l y o u h e a r i t c l i c k i n t o p l a c e , t h e n c o n n e c t t h e c o n n e c t o r '
4. Bleed the brake system, starting with the front wheels.
5. Start the engine, and check that the ABS indicator goes off.
6. Test-drive the vehicle, and check that the ABS indicator does not come on
19-59