Honda S2000 Service Manual page 369

8 .
9 .
Turn the ignition switch ON (ll).
Measure voltage between EVAP purge canister
valve 2P connector terminal No. 1 and body ground.
EVAP CANISTER PURGE
VALVE 2P CONNECTOR
Z
IG1 {BLK/YEL)
Wire side o{ f€male terminals
ls there battery voltage?
YES Replace the EVAP canister purge valve.I
NO - Repair open in the wire between the EVAP
canister purge valve and the No. 6 ACG (15 A)
f u s e . l
EVAP Bypass Solenoid Valve Test
10. Disconnect both vacuum hoses from the EVAP two
way valve {A), and connect a vacuum pump to the
canister port on the two way valve.
A
Turn the ignition switch ON (ll).
Apply vacuum to the hose.
Does the valve hold vacuum?
YES The EVAP bypass solenoid valve/EVAP two
way valve is OK. Go to step 18,
NO Go to step 13.
Turn the ignition switch OFF.
Disconnect the EVAP bypass solenoid valve 2P
connecror.
Check for continuity between EVAP bypass
solenoid valve 2P connector terminal No. 2 and
body ground.
EVAP BYPASS SOLENOID
VALVE 2P CONNECTOR
l
2
2WBS
{ORN}
o
1 1 .
1 2 .
t 5 .
't 4.
(cont'd)
11-141
Wire side of female terminals