ABS Components
General Troubleshooting Information (cont'd)
7 .
Turn the ignition switch ON (ll) while continuing to
press the brake pedal.
After the ABS indicator goes off, release the brake
peoar.
After the ABS indicator comes on, press the brake
p e d a l a g a i n .
After the ABS indicator goes off, release the brake
p e o a r .
You cannot clear the DTC unless these conditions
are met;
. The vehicle speed is 6 mph (10 km/h) or less.
. The SCS circuit is shorted to body ground before
the ignition switch is turned ON (ll).
. The brake pedal is pressed before the ignition
switch is turned ON (ll).
19-36
1 0 .
After a few seconds, the ABS indicator blinks twice
and the DTC is cleared. lf the indicator does not
b l i n k t w i c e , r e p e a t s t e o s l t h r u 7 . l f t h e A B S
indicator stays on after it blinks twice, check the
DTC, because a problem was detected during initial
diagnosis before shifting to DTC clearing mode.
Turn the ignition switch OFF.
Disconnect the Honda PGM Tester from the DLC.