Honda S2000 Service Manual page 571

EPS Gomponents
Steering Gearbox Removal and Installation (cont'd)
1 3 . i n s t a l l t h e s t e e r i n g w h e e l ( s e e p a g e 1 7 - 8 ) .
1 4 . I n s t a l l t h e d r i v e r ' s a i r b a g ( s e e p a g e 2 3 - 6 5 ) .
15. Reconnectthe negative cable to the battery.
16. Install the front wheels, and adjust the front wheel
alignment (see page 18-5).
17. After installation, perform the following checks.
. Make sure the steering gearbox wires are not
caught or pinched by any parts.
. Make sure the steering gearbox connectors are
properly connected.
. T u r n t h e i g n i t i o n s w i t c h O N { l l ) , a n d c h e c k t h a t
the EPS indicator goes off,
' lf you replacedthe steering gearbox assembly,
let the EPS control unit memorize the torque
sensor neutral position (see page 17-45).
. Test-drive the vehicle;
- Check that the EPS indicator light does not
c o m e o n .
- Check the steering wheel spoke angle. Recheck
and adlust the front wheel alignment, if
necessary.
. Reset the radio presets.
. F o r ' 0 1 - 0 3 m o d e l s ; s e t t h e c l o c k .
17-52