Gylinder Head
Cylinder Head Cover Installation (cont'dl
3. Inspect the cylinder head cover washers. Replace
any washers and rubber seals that are damagedor
deteriorated.
4. Clean the washer mating surfaces ofthe cylinder
neao cover.
5. lnstallthe head cover washers (A).
6. Make sure the rubber seals (B) are securely seated
on the cylinder head cover.
7. Tighten the bolts in two orthree steps. ln the final
step, tighten all bolts, in sequence, to 12 N.m
{ 1 . 2 k g f . m , 8 . 7 l b f . f t ) .
6-54
8 . I n s t a l l t h e i g n i t i o n c o i l s ( A ) , t h e n i n s t a l l t h e i g n i t i o n
c o i l c o v e r ( B ) .
x 1 . 0 m m
g
1 2 N . m
{1.2 kgf m,
8.7 tbt.ft)
6 x 1 . 0 m m
1 2 N . m
(1.2 kg{.m,9.7lbf.ftl
Install the Dositive crankcase ventilation (PCV)
hose (A) and breather hose {B), then insert the
dipstick (C).
After assemblv, wait at least 30 minutes before
f i l l i n g t h e e n g i n e w i t h o i l { s e e p a g e 8 - 5 ) .
1 0 .
:,)