Table of Contents
Advertisement
EPS Components
Gearbox Bracket RemovaU
lnstallation
1. Remove the bracket clamo bolt (A) from the
gearbox bracket (B), then pry open the bracket to
remove it from the gearbox.
Install the gearbox bracket on the gearbox with the
bracket clamp bolt toward the rear.
Adjust the distance between the bracket mounting
bolt hole {A} and the gearbox mounting bolt hole
(B) to the dimension shown. Make sure the bracket
mounting bolt holes are parallel with gearbox
mountlng bolt holes.
2 .
A
8 x 1.25 mm
25 N.m 12.5 kgf.m,
18 tbf.ft)
4. Installthe bracket clamp bolt, and tighten it to 25 N.
m (2.5 kgf.m, 18 lbf ft).
17-58
Ball Joint Boot Replacement
SpecialTools Required
Oil seal driver, 07974-6790000
1. Remove the boot from the tie-rod end, and wipe the
old grease off the ball pin.
2 . P a c k t h e l o w e r a r e a o f t h e b a l l p i n ( A ) w i t h f r e s h
mult| purpose grease.
Pack the interior of the new boot (B) and lip {C) with
fresh multipurpose grease.
Note these items when installing new grease:
. Keep grease off the boot installation section (D)
and the tapered section (E) if the ball pin.
. Do not allow dust, dirt, or other foreign materials
to enter the boot.
I n s t a l l t h e n e w b o o t { A ) u s i n g t h e s p e c i a l t o o l . T h e
boot must not have a gap at the boot installation
sections (B). After installing the boot, check the ball
pin tapered section for grease contamination, and
wipe it ii necessary.
07974-6790000
-Gl
A
4.
Advertisement
Table of Contents
Troubleshooting
