Rubber Dams, Fasteners, And Spacers Installation; Molding Installation (Rear Window) - Honda S2000 Service Manual

Rubber Dams, Fasteners, and Spacers Installation
. Be sure the rubber dams, fasteners, and spacers line up with the alignment marks.
. G l u e t h e u p p e r f a s t e n e r w i t h a d h e s i v e t a p e ( 3 M 4 2 1 5 , o r e q u i v a l e n t ) a n d t h e l o w e r f a s t e n e r w i t h a d h e s i v e t a D e
( 3 M 5 3 1 2 , o r e q u i v a l e n t ) .
. G l u e t h e r u b b e r d a m s a n d s p a c e r s w i t h a d h e s i v e t a p e ( N I T T O 5 0 1 M , o r e q u i v a l e n t ) .
UPPER
FASTENER
lTwo Places)
srDE RUBBER DAM
A L I G N M E N T
M A R K S
ALIGNMENT
MARK ./
ALIGNMENT MARK
"u"".i oarrr
RUBBER
DAM
Apply primer and
urethane adhesive,
16 mm REAR WINDOW
17"?ii?!i"*'
$Ao.'nr".Nr
MARKS
FASTENER
REAR WINOOW
(Two places)
SPACER
ALIGNMENT MARKS
Molding lnstallation
To g\ue the molding, apply a light coat o{ pr'rmer (3M N-2O0, or equrvalent) to the bottom area on the ou$-rde of rhe
rear window , and glue the molding with urethane adhesive.
(cont'd)
REAR wlNDOW
20-33