Front Brake Caliper Overhaul
Do not spill brake fluid on the vehicle; it may damage the paint; lf brake fluid gets on the paint, wash it off
immediately with water.
To prevent dripping, cover disconnected hose joints with rags or shop towels.
Clean all parts in brake fluid and air dry; blow out all passages with compressed air.
Before reassembling, check that all parts are free of dirt and other foreign particles.
Replace parts with new ones as specified in the illustration.
Make sure no dirt or other foreign matter gets in the brake fluid,
Make sure no grease or oil gets on the brake discs or pads.
When reusing pads, always reinstall them in their original positions to prevent loss of braking efficiency.
Do not reuse drained brake fluid.
Always use Honda DOT 3 Brake Fluid.
Coatthe piston, piston seal groove, and caliper bore with clean brake fluid.
Replace all rubber parts with new ones.
After installing the caliper, check the brake hose and line for leaks, interference, and twisting.
a
- r
c F r a s E i J :
H o n d a ( a l i p c r o r e a s e ( P N 0 8 C 3 0 8 0 2 3 4 M )
8 x 1.25 mm
CALIPEB AOLT
32 N.m {3.3 kgf m,
BRAKE HOSE
S E A L I N G W A S H E R S
I N N E R S H I M B
---------*d.
0, l
t /
W
WEAR INDICATON
Install inner pad w th
its wear indicator downward.
CALIPER EODY
PISTON BOOT
6-=^"
.:
q!!4s!n
PIN BOOT
' 1 2
x 1 . 2 5 m m
FLANGE BOLTS
1 0 8 N m { 1 1 . 0 k g t . m ,
79.5 tbf.ft)
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
. Avoid breathing dust particles.
. Never use an air hose or brush to clean brake assemblies. Use an OSHA-aooroved vacuum cleaner.
Remove, disassemble, inspect, reassemble, and install the caliper, and note these items:
CALIPEF
BRACKET
=^.
#.q!A9$
PtN AOOTS
Replace.
BANJO BOLT
3 4 N m
{3.5 kg{ m,
25 tbf.ftl
I N N E R S H I M A
OUTER
P A D S H I M
\
BRAKE PADS
BRACKET
1 9 - 1 5