Coolant Replacement - Honda S2000 Service Manual

Cooling System
Coolant Replacement
1 .
Set the heater temperature control dial to
maximum heat.
Remove the radiator cap.
Loosen the drain plug (A), and drain the coolant.
Remove the drain bolt (A) from the right side of
cvlinder block.
,-,t---
the
A
83 N.m
(8.5 kgf.m,61 lbf.ftl
After the coolant has drained, apply liquid gasket,
P/N 08718-0009, to the drain bolt threads, then
reinstall the bolt with a new washer and tighten
it securely.
Tighten the radiator drain plug securely.
10-8
7 . R e m o v e , d r a i n , a n d r e i n s t a l l t h e r e s e r v o i r . F i l l t h e
tank to the MAX mark with Honda All Season
Antifreeze/Coolant Type 2 (P/N O1999-9001).
Remove the bleed cap (A)from the heater bypass
tube.
Loosen the air bleed bolt (A) in the intake manifold.
then pour Honda All Season Antifreeze/Coolant
Tvoe 2 into the radiator to the bottom of the filler
neck. Do not let coolant spill on any electrical parts
or the paint. lf any coolant spills, rinse it off
immedeately.
NOTE:
. Always use Honda All Season Antifreeze/Coolant
Type 2 (P/N OL999-9001). Using a non-Honda
coolant can result in corrosion, causing the
cooling system to malfunction or fail.
. Honda All Season Antifreeze/Coolant Tvpe 2 is a
mixture of 50% antifreeze and 50% water.
Premixing is not required.
Engine Coolant Rsfill Capacity Iincluding
reservoir capacity or 0.6 0 (0.6 US qt)l:
6.5 0 (6.9 US $l
9.8 N.m {1.0 kgt.m,7.2lbl.ft)
9 .