Dtc 4-4: Short To Power In Passenger's Seat Belt Tensioner - Honda S2000 Service Manual

sRs
DTC Troubleshooting (cont'dl
DTC 4-4: Short to Power in Passenger's Seat
Belt Tensioner
Special Tools Required
. SRS inflator simulator 07SAZ-T840'l1A
. SRS simulator lead C 07TAZ-S25011A
1 . E r a s e t h e D T C m e m o r y ( s e e p a g e 2 3 - 1 9 ) .
2 . T u r n t h e i g n i t i o n s w i t c h O N ( l l ) , a n d c h e c k t h a t t h e
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicatot stay on?
YES Go to step 3.
NO - Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
p a g e 2 3 - 1 9 ) .
3. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the passenger's seat belt tensioner 2P
connector from the SRS main harness.
AZ-S25011A
\
orror-r"oor ro
C o n n e c t t h e S R S i n f l a t o r s i m u l a t o r ( 2 Q c o n n e c t o r )
a n d t h e s i m u l a t o r l e a d t o t h e S R S m a i n h a r n e s s .
23-50
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 4-4 ind icated?
YES Go to step 9.
NO Short to power in the passenger's seat belt
tensioner; replace the passenger's seat belt (see
p a g e 2 3 - 4 ) . 1
9. Turn the ignition switch OFF, then disconnectthe
battery negative cable, and wait for 3 minutes.