Honda S2000 Service Manual page 493

1 0 . I n s t a l l t h e s p e c i a l t o o l t o t h e c o m p a n i o n f l a n g e ,
then tighten the locknut to 20 N.m (2.0 kgf.m,
14 tbf.ft).
07RAa-TB40t0B
Rotate the drive oinion several times to assure
proper tapered roller bearing contact. Measure the
drive pinion turning torque.
1
' I.
'-.'-- -.
/ ,..'it .
'. i ir Li'
| .:"1 '
'i-r
1 2 . T i g h t e n t h e l o c k n u t t o 1 2 7 N . m ( 1 3 . 0 k g f . m .
94 lbf.ft), then remove the sDecial tool.
07RAB.TB4O1OB
Rotate the drive oinion several times to assure
proper tapered roller bearing contact. Measure the
drive pinion turning torque.
' lf the drive pinion turning torque exceedsthe
standard, replace the distance piece.
. l f t h e d r i v e p i n i o n t u r n i n g t o r q u e
l e s s t h a n t h e
standard, adjust by tightening the locknut a little
at a time, but keep the torque within 127 - 284
N . m ( 1 3 . 0 2 9 . 0 k g f . m , 9 4 2 1 0 l b f . f t ) . l f t h i s i s
not possible, replace the pinion spacer.
Turning Torque:
0.88 1.37 N.m (9.0 14.0 kgf.cm.
7.8 12. t lbf.in) +Tp(lromstep11)
Tp: Actual measurement of drive pinion turning
torq ue
{cont'd)
15-21