Display Cluster Candidates - 3Com 5500-EI PWR Reference Manual

Handshake timer:10 sec
Handshake hold-time:60 sec
Administrator device mac address:000f-e20f-3901
Administrator status:Up
Table 1-5 Description on the fields of the display cluster command
Cluster name
Role
Management-vlan
Member number
Handshake timer
Handshake hold-time
Administrator device mac address
Administrator status

display cluster candidates

Syntax
display cluster candidates [ mac-address H-H-H | verbose ]
View
Any view
Parameters
mac-address H-H-H: Specifies a candidate device by its MAC address. H-H-H represents the MAC
address.
verbose: Displays detailed information about candidate devices.
Description
Use the display cluster candidates command to display information about one specified or all
candidate devices of a cluster.
You can only use this command on a management device.
Note that, after a cluster is set up on an S3600 series switch, the switch will collect the topology
information of the network at the topology collection interval you set and automatically add the
candidate devices it discovers into the cluster. As a result, if the topology collection interval is too short
(the default interval is 1 minute), the switches acting as candidate devices will not keep in candidate
state for a long time – they will change to member devices within a short time. If you do not want the
Field
1-24
Description
Name of the cluster, which can be configured
through the build command
Role of this switch
Number of the management VLAN, which can be
configured through the management-vlan
command
Member number of this switch
Interval to send handshake packets, which can
be configured through the timer command
Holdtime of the neighbor status information,
which can be configured through the holdtime
command
MAC address of the management device
Status of the management device