Line-Rate - 3Com 5500-EI PWR Reference Manual

Examples
# Display the global queue scheduling configuration.
<Sysname> display queue-scheduler
Queue scheduling mode: weighted round robin
weight of queue 0: 1
weight of queue 1: 2
weight of queue 2: 3
weight of queue 3: 4
weight of queue 4: 5
weight of queue 5: 9
weight of queue 6: 13
weight of queue 7: 15
Refer to Table 1-3

line-rate

Syntax
line-rate { inbound | outbound } target-rate [ burst-bucket burst-bucket-size ]
undo line-rate{ inbound | outbound }
View
Ethernet port view
Parameters
inbound: Limits the inbound packet rate.
outbound: Limits the outbound packet rate.
target-rate: Total target rate (in kbps). The range of this argument varies with port type as
follows:
Fast Ethernet port: 64 to 99,968;
GigabitEthernet port: 64 to 1,000,000.
The granularity of port rate limit is 64 kbps. Assume that the value you provide for the
target-rate argument is in the range N*64 to (N+1)*64 (N is a natural number), it will be
rounded off to (N+1)*64.
burst-bucket burst-bucket-size: Specifies the maximum burst traffic size (in KB). This is
the buffer size provided for burst traffic while traffic is being forwarding or received at the
rate of target-rate. The burst-bucket-size argument must be an integer power of 2, in the
range of 4 to 512. If it is not specified, 512 KB applies by default.
Description
Use the line-rate command to limit the rate of the inbound or outbound packets on a port.
Use the undo line-rate command to cancel the line rate configuration.
for the description of the output fields.
1-12