Static-Rpf-Peer - 3Com 5500-EI PWR Reference Manual

undo shutdown peer-address
View
MSDP view
Parameters
peer-address: Specifies an MSDP peer by its IP address.
Description
Use the shutdown command to shut down the connection with the specified MSDP peer.
Use the undo shutdown command to reactivate an MSDP peering connection.
By default, the connections with all MSDP peers are active.
Related commands: display msdp peer-status.
Examples
# Shut down the MSDP peer 125.10.7.6.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] msdp
[Sysname-msdp] shutdown 125.10.7.6

static-rpf-peer

Syntax
static-rpf-peer peer-address [ rp-policy ip-prefix-name ]
undo static-rpf-peer peer-address
View
MSDP view
Parameters
peer-address: Address of the static RPF peer to receive SA messages.
rp-policy ip-prefix-name: Specifies a filtering policy based on RP addresses to filter RPs in SA
messages, where ip-prefix-name is the IP address prefix list containing 1 to 19 characters.
Description
Use the static-rpf-peer command to configure a static RPF peer.
Use the undo static-rpf-peer command to remove a static RPF peer.
By default, no static RPF peer is configured.
If only one MSDP peer is configured with the peer command, the MSDP peer will be regarded as a
static RPF peer. When configuring multiple static RPF peers for the same switch, make sure you follow
the following two configuration methods:
Use the rp-policy keyword for all the MSDP peers. In the case, multiple static RPF peers take
effect at the same time. RPs in SA messages are filtered according to the prefix list configured; only
SA messages whose RP addresses pass the filtering are received. If multiple static RPF peers
4-18