Display This - 3Com 5500-EI PWR Reference Manual

Table 1-2 Description on the fields of the display startup command
Field
Current Startup
saved-configuration file
Next main startup
saved-configuration file
Next backup startup
saved-configuration file
Bootrom-access enable state

display this

Syntax
display this [ by-linenum ]
View
Any view
Parameters
by-linenum: Displays configuration information with line numbers.
Description
Use the display this command to display the current configuration performed in the current view. To
verify the configuration performed in a view, you can use this command to display the parameters that
are valid in the current view.
Note that:
Effective parameters that are the same as the default are not displayed.
The configured parameter whose corresponding function does not take effect is not displayed.
Execution of this command in any user interface view or VLAN view displays the valid configuration
parameters in all user interfaces or VLANs.
Related commands: save, reset saved-configuration, display saved-configuration, display
current-configuration.
Examples
# Display the configuration parameters that take effect in all user interface views.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
The configuration file used for the current startup
The main configuration file used for the next startup
The backup configuration file used for the next startup
Whether you can use the user-defined password to access the
Boot ROM:
enabled indicates you can access the Boot ROM with the
user-defined password.
disabled indicates you cannot access the Boot ROM with the
user-defined password.
For related information, refer to the startup bootrom-access
enable command in the File System Management part of the
manual.
1-9
Description