3Com 5500-EI PWR Reference Manual page 906

View
Any view
Parameters
mac-address: MAC address of the device whose detailed information is to be displayed.
Description
Use the display ntdp single-device mac-address command to display the detailed information, which
is collected through NTDP protocol packets, about a single device. The information displayed by the
command is similar to that displayed by the display cluster members command. However, if you want
to display information about a device that is enabled with only NTDP and is not in any cluster, you have
to use the display ntdp single-device mac-address command.
Examples
# Display the detailed information about the switch with the MAC address 000f-e200-3956.
<Sysname> display ntdp single-device mac-address 000f-e200-3956
Hostname : 3Com
MAC : 000f-e200-3956
Hop : 0
Platform : Switch 5500-EI
IP :
Version:
3Com Corporation
Switch 5500-EI Software Version 3Com OS V3.03.02s56e
Copyright (c) 2004-2008 3Com Corporation and its licensors, All rights reserved.
Switch 5500-EI 28-Port
Cluster :
Peer MAC
000f-e239-1333
Table 1-12 Description on the fields of the display ntdp single-device command
Hostname
MAC
Hop
Platform
IP
Version
Cluster
Peer MAC
Switch 5500-EI V3.03.02s56e
Candidate switch
Peer Port ID
Ethernet1/0/4
Field
Native Port ID
Ethernet1/0/10
System name of a device
MAC address of the device
Number of hops from the device to the topology-collecting
device
Platform information of the device
IP address and mask length of the management VLAN
interface of the device
Version information
Role the device plays in the cluster
MAC address of the peer device
1-44
Speed Duplex
100 FULL
Description