Dldp - 3Com 5500-EI PWR Reference Manual

Table 1-1 Description on the fields of the display dldp command
dldp interval
dldp work-mode
dldp authentication-mode
password
dldp unidirectional-shutdown
dldp delaydown-timer
The port number of unit 1 with DLDP
interface GigabitEthernet1/0/49
dldp port state
dldp link state
The neighbor number of the port
neighbor mac address
neighbor port index
neighbor state
neighbor aged time

dldp

Syntax
dldp { enable | disable }
View
System view/Ethernet port view
Parameters
None
Description
In system view:
Use the dldp enable command to enable DLDP on all optical ports of the switch.
Use the dldp disable command to disable DLDP on all optical ports of the switch.
In Ethernet port view:
Use the dldp enable command to enable DLDP on the current port.
Use the dldp disable command to disable DLDP on the current port.
The dldp command can apply to a non-optical port as well as an optical port.
By default, DLDP is disabled.
Field Description
Interval for sending DLDP advertisement packets (in
seconds)
DLDP work mode (enhance or normal)
DLDP authentication mode (none, simple, or md5)
Password for DLDP authentication
DLDP action to be performed on detecting a
unidirectional link (auto or manual)
Setting of the DelayDown timer
Number of the DLDP-enabled ports on unit 1
Port type and port number
DLDP state on a port (initial, inactive, active,
advertisement, probe, disable, or delaydown)
Port state (up or down)
Number of the neighbor ports
MAC address of a neighbor port
Neighbor port index
Neighbor state (unknown, one way, or two way)
Neighbor aging time
1-2