3Com 5500-EI PWR Reference Manual page 126

If you specify a source aggregation group ID, the system uses the port with the smallest port
number in the aggregation group as the source.
If you specify a destination aggregation group ID, the configuration of the source port will be copied
to all ports in the aggregation group and all ports in the group will have the same configuration as
that of the source port.
Refer to Table 1-1
Table 1-1 Configurations that can be copied
Configuration category
VLAN
Protocol-based VLAN
LACP (Link Aggregation
Control protocol)
QoS
STP
GARP
Basic port configuration
In case a configuration setting fails to be copied, the system will print the error message.
Examples
# Copy the configurations of Ethernet 1/0/1 to Ethernet 1/0/2 and Ethernet 1/0/3.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] copy configuration source ethernet 1/0/1 destination ethernet 1/0/2 ethernet 1/0/3
Note: The following will be removed from destination port list:
Aggregation port(s), Voice vlan port(s).
Copying VLAN configuration...
Copying Protocol based VLAN configuration...
Copying LACP configuration...
Copying QOS configuration...
Copying GARP configuration...
Copying STP configuration...
for the configurations that can be copied.
VLANs carried on the port and the default VLAN ID.
Protocol VLAN IDs and protocol indexes.
The enable/disable status of LACP.
(As the configuration commands of manual and static link
aggregation groups cannot be copied, you cannot assign a port to a
link aggregation group with the copy command.)
Traffic policing, packet priority marking, port priority, traffic
accounting, VLAN mapping, port rate limiting, priority trust mode,
QoS profile (the qos-profile port-based configuration cannot be
copied), and so on.
The enable/disable state of STP on the port, link attribute of the port
(point-to-point or non-point-to-point), STP priority, path cost,
transmission rate limit, enable/disable state of loop protection,
enable/disable state of root protection, and whether the port is an
edge port.
GVRP enable/disable status, timer settings, and registration mode.
Link type of the port, port rate, and duplex mode.
Contents
1-3