Domain Delimiter - 3Com 5500-EI PWR Reference Manual

default: Manually changes the default ISP domain, which is "system" by default. There is one and only
one default ISP domain.
disable: Disables the configured default ISP domain.
enable: Enables the configured default ISP domain.
Description
Use the domain command to create an ISP domain and enter its view, or enter the view of an existing
ISP domain, or configure the default ISP domain.
Use the undo domain command to delete a specified ISP domain.
The ISP domain "system" is used as the default ISP domain before you manually configure the default
ISP domain, and you can use the display domain command to check the settings of the default ISP
domain "system".
After you execute the domain command, the system creates a new ISP domain if the specified ISP
domain does not exist. Once an ISP domain is created, it is in the active state. You can manually
specify an ISP domain as the default domain only when the specified domain already exists.
Related commands: access-limit, scheme, state, display domain.
Examples
# Create a new ISP domain named aabbcc.net.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] domain aabbcc.net
New Domain added.
[Sysname-isp-aabbcc.net]
# Create a new ISP domain named 01234567891234567 (note that it will appear as
012345678912345~0001 in the view prompt).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname]domain 01234567891234567
New Domain added.
[Sysname-isp-012345678912345~0001]

domain delimiter

Syntax
domain delimiter { at | dot }
undo domain delimiter
View
System view
1-15