Gvrp Configuration Commands; Garp Configuration Commands; Display Garp Statistics - 3Com 5500-EI PWR Reference Manual

Hide thumbs Also See for 5500-EI PWR:

Table of Contents

GVRP Configuration Commands

display garp statistics [ interface interface-list ]

interface-list: Specifies a list of Ethernet ports for which the statistics about GARP are to be displayed. In

this list, you can specify individual ports and port ranges. An individual port takes the form of

interface-type interface-number and a port range takes the form of interface-type interface-number1 to

interface-type

interface-number1. The total number of individual ports and port ranges defined in the list must not

Use the display garp statistics command to display the GARP statistics of the specified or all ports. If

the interface interface-list keyword-argument combination is not specified, this command displays the

GARP statistics on all the ports.

The switch automatically collects statistics about GVRP packets sent, received and dropped on

GVRP-enabled ports. Upon system reboot or the execution of the reset garp statistics command, the

system automatically deletes the statistics and starts collecting statistics again. You can check whether

GVRP is running normally on a port by checking the GVRP statistics on it:

If the number of received GVRP packets and the number of sent GVRP packets are the same as

those on the remote port, it indicates that the ports are transmitting and receiving GVRP packets

normally and no registration information is lost.

If the number of dropped GVRP packets is not 0, it indicates that the registration mode on the port

may be fixed or forbidden. As in either mode dynamic VLANs cannot be registered, GVRP packet

drop may occur on the port.

# Display the GARP statistics on Ethernet1/0/1 and Ethernet 1/0/2.

<Sysname> display garp statistics interface Ethernet 1/0/1 to Ethernet 1/0/2

interface-number2,

interface-number2

Table of Contents

5500-ei series