Remote-Probe Vlan Enable - 3Com 5500-EI PWR Reference Manual

It is recommended that you use a destination port for port mirroring purpose only. Do
not use a destination port to transmit other service packets.
Related commands: display mirroring-group.
When you configure mirroring destination port on an Ethernet port of a Switch 5500-EI, if
mirroring group 1 does not exist, the switch will automatically create local mirroring group
1 and add the destination port to the group; if mirroring group 1 already exists, but is not a
local mirroring group, your configuration of the destination port will fail.
Examples
# Configure Ethernet 1/0/4 as a destination port in Ethernet port view.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Ethernet 1/0/4
[Sysname-Ethernet1/0/4] monitor-port

remote-probe vlan enable

Syntax
remote-probe vlan enable
undo remote-probe vlan enable
View
VLAN view
Parameters
None
Description
Use the remote-probe vlan enable command to configure the current VLAN as the
remote-probe VLAN.
Use the undo remote-probe vlan enable command to restore the remote-probe VLAN to
a normal VLAN.
Note that:
You cannot configure a default VLAN, a management VLAN, or a dynamic VLAN as the
remote-probe VLAN.
A remote-probe VLAN cannot be removed directly. To do that, you need to run the
undo remote-probe vlan enable command in VLAN view first.
1-9