Snmp-Host; Tftp Get - 3Com 5500-EI PWR Reference Manual

Examples
# Reboot number-2 member device.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] reboot member 2

snmp-host

Syntax
snmp-host ip-address
undo snmp-host
View
Cluster view
Parameters
ip-address: IP address of a SNMP network management station (NMS) to be configured for the cluster.
Description
Use the snmp-host command to configure a shared SNMP NMS for the cluster on the management
device.
Use the undo snmp-host command to remove the shared SNMP NMS setting.
By default, no shared SNMP NMS is configured.
After setting the IP address of an SNMP NMS for the cluster, the member devices in the cluster can
send trap messages to the SNMP NMS through the management device.
Note that, you can only use the commands on a management device.
For how to configure a switch to send trap messages to the SNMP NMS, refer to Information Center
Operation.
Examples
# Configure SNMP NMS address 1.0.0.9 on the management device for the cluster.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] snmp-host 1.0.0.9

tftp get

Syntax
tftp { cluster | tftp-server } get source-file [ destination-file ]
View
User view
1-34