Ftp-Server; Holdtime - 3Com 5500-EI PWR Reference Manual

ftp-server

Syntax
ftp-server ip-address
undo ftp-server
View
Cluster view
Parameters
ip-address: IP address of the FTP server to be configured for the cluster.
Description
Use the ftp-server command to configure a shared FTP server for the cluster on the management
device.
Use the undo ftp-server command to remove the shared FTP server setting.
By default, the management device acts as the shared FTP server of the cluster.
After you configure the IP address of the shared FTP server on the management device, the member
devices in the cluster can access the shared FTP sever through the management device to back up
configuration and download software. The IP address of the shared FTP server configured on the
management device takes effect on the management device only and will not be applied to the member
devices through the cluster management packets.
After the IP address of the shared FTP server is configured, network address translation (NAT) is
enabled on the management device immediately. When a member device uses the ftp cluster
command to access the shared FTP server, the management device will translate the private IP
address of the member device to a public network address, forward the requests of the member device
to the FTP server, and forward the responses of FTP server to the member device according to the NAT
record.
Examples
# Configure FTP server 1.0.0.9 on the management device of a cluster.
<aaa_0.Sysname> system-view
System View: return to User View with Ctrl+Z.
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] ftp-server 1.0.0.9

holdtime

Syntax
holdtime seconds
undo holdtime
View
Cluster view
1-29