Tftp-Server - 3Com 5500-EI PWR Reference Manual

Description
Use the tftp put command to upload a file from the switch to a specified directory on the TFTP server.
You can use the tftp-server command on the management device to configure the shared TFTP server
of the cluster, which is used for software version update and configuration file backup of the cluster
members. For TFTP server rights and directory configuration, refer to the user guide of the TFTP server
software.
Related commands: tftp get,tftp-server.
You need to specify the cluster keyword completely in the command.
Examples
# Upload file config.cfg on the switch to the shared TFTP server of the cluster and save it as temp.cfg.
<123_1.Sysname> tftp cluster put config.cfg temp.cfg

tftp-server

Syntax
tftp-server ip-address
undo tftp-server
View
Cluster view
Parameters
ip-address: IP address of a TFTP server to be configured for the cluster.
Description
Use the tftp-server command to configure a shared TFTP server for the cluster on the management
device.
Use the undo tftp-server command to remove the shared TFTP server setting.
By default, no shared TFTP server is configured.
After the IP address of the shared TFTP server is configured, NAT is enabled on the management
device immediately. When a member device uses the tftp cluster get or tftp cluster put command to
download or upload a file from the shared TFTP server, the management device translates the private
IP address of the member device to a public network address, forwards the requests of the member
device to the TFTP server, and forwards the responses of TFTP server to the member device according
to the NAT record.
Note that you can only use the commands on a management device.
1-36