3Com 5500-EI PWR Reference Manual page 757

Name
port-unreachable
protocol-unreachable
reassembly-timeout
source-quench
source-route-failed
timestamp-reply
timestamp-request
ttl-exceeded
Parameters of the undo rule command
rule-id: Rule ID, which must the ID of an existing ACL rule. You can obtain the ID of an ACL rule by
using the display acl command.
source: Removes the settings concerning the source address in the ACL rule.
source-port: Removes the settings concerning the source port in the ACL rule. This keyword is only
available to the ACL rules with their protocol types set to TCP or UDP.
destination: Removes the settings concerning the destination address in the ACL rule.
destination-port: Removes the settings concerning the destination port in the ACL rule. This keyword
is only available to the ACL rules with their protocol types set to TCP or UDP.
icmp-type: Removes the settings concerning the ICMP type and message code in the ACL rule. This
keyword is only available to the ACL rules with their protocol type set to ICMP.
precedence: Removes the precedence-related settings in the ACL rule.
tos: Removes the ToS-related settings in the ACL rule.
dscp: Removes the DSCP-related settings in the ACL rule.
time-range: Removes the time range settings in the ACL rule.
fragment: Removes the settings concerning non-tail fragments in the ACL rule.
Description
Use the rule command to define an ACL rule.
Use the undo rule command to remove an ACL rule or specified settings of an ACL rule.
To remove an ACL rule using the undo rule command, you need to provide the ID of the ACL rule. If no
other arguments are specified, the entire ACL rule is removed. Otherwise, only the specified
information of the ACL rule is removed.
Note that:
With the config match order specified for the advanced ACL, you can modify any existent rule.
The unmodified part of the rule remains. With the auto match order specified for the ACL, you
cannot modify any existent rule; otherwise the system prompts error information.
ICMP type
Type=3
Type=3
Type=11
Type=4
Type=3
Type=14
Type=13
Type=11
1-18
ICMP code
Code=3
Code=2
Code=1
Code=0
Code=5
Code=0
Code=0
Code=0