3Com 5500-EI PWR Reference Manual page 3

CLI view
mst-region
mtlk-group
null
ospf
ospf-area
peer-key-code
peer-public-key
pim
poe-profile
qinq
qos-profile
radius-template
remote-ping
rip
route-policy
shell
smlk-group
system
user-interface
vlan
vlan-interface
command: Command for which the level is to be set.
Description
Use the command-privilege level command to set the level of a specified command in a
specified view.
Use the undo command-privilege view command to restore the default.
Commands fall into four levels: visit (level 0), monitor (level 1), system (level 2), and
manage (level 3). The administrator can change the level of a command as required. For
example, the administrator can change a command from a higher level to a lower level so
that the lower level users can use the command.
The default levels of commands are described in the following table:
Table 1-2 Default levels of commands
Level
0 Visit level
Name
Commands used to diagnose network, such as ping,
tracert, and telnet commands.
Description
MST region view
Monitor link group view
NULL interface view
OSPF view
OSPF area view
Public key editing view
Public key view
PIM view
PoE profile view
QinQ view
QoS profile view
RADIUS scheme view
Remote-ping test group view
RIP view
Routing policy view
User view
Smart link group view
System view
User interface view
VLAN view
VLAN interface view
Command
1-2