Protocol-Vlan - 3Com 5500-EI PWR Reference Manual

Hide thumbs Also See for 5500-EI PWR:
Table of Contents

Advertisement

The port hybrid protocol-vlan vlan command can be executed on hybrid ports only.
Before you associate a port with the protocol-based VLAN, make sure the port belongs to the
protocol-based VLAN.
When the undo port hybrid protocol-vlan vlan command is being executed, the switch will
prompt operation failure if the index of the specified protocol to be removed does not exist. If a part
of the specified protocol indexes to be removed do not exist, the switch will remove the existing
indexes when it prompts errors.
Related command: display protocol-vlan interface.
Example
# Associate GigabitEthernet1/0/1 with the protocols indexed from 0 to 4 of VLAN 3 (assuming that
VLAN 3 is a protocol-based VLAN).
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port hybrid protocol-vlan vlan 3 0 to 4

protocol-vlan

Syntax
protocol-vlan [ protocol-index ] { at | ip | ipx { ethernetii | llc | raw | snap } | mode { ethernetii etype
etype-id | llc dsap dsap-id ssap ssap-id | snap etype etype-id } }
undo protocol-vlan { protocol-index [ to protocol-index-end ] | all }
View
VLAN view
Parameter
at: Specifies the VLAN to be an AppleTalk-based VLAN.
ip: Specifies the VLAN to be an IP-based VLAN.
ipx: Specifies the VLAN to be an IPX-based VLAN. The ethernetii, llc, raw and snap keywords specify
the four IPX encapsulation types.
mode: Configures user-defined protocol templates.
ethernetii etype-id: Matches the Ethernet II encapsulation format and the corresponding protocol type
value of the packet. The etype-id argument ranges from 0x0600 to 0xFFFF.
llc: Matches LLC encapsulation format.
dsap-id: Destination service access point. This argument ranges 0x0000 to 0x00FF.
ssap-id: Source service access point. This argument ranges from 0x0000 to 0x00FF.
snap etype-id: Matches SNAP encapsulation format and the corresponding protocol type value of the
packet. The etype-id argument ranges from 0x0600 to 0xFFFF.
1-15

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

5500-ei series

Table of Contents