Movemanagement; Ping - Dell PowerConnect 8024 Cli Reference Manual

movemanagement

Use the movemanagement command in Stack Global Configuration mode to move the
Management Switch functionality from one switch to another.
Syntax
movemanagement
fromunit — The switch identifier on the current Management Switch.
•
tounit — The switch identifier on the new Management Switch.
•
Default Configuration
This command has no default configuration.
Command Mode
Stack Global Configuration mode
User Guidelines
Upon execution, the entire stack, including all interfaces in the stack, are unconfigured and
reconfigured with the configuration on the new Management Switch.
After the reload is complete, all stack management capability must be performed on the new
Management Switch.
To preserve the current configuration across a stack move, execute the copy configuration
command before performing the stack move. A stack move causes all routes and layer 2
addresses to be lost. This command is executed on the Management Switch. The administrator
is prompted to confirm the management move.
Example
The following example displays how to move the Management Switch functionality from switch
"1" to switch "8."
console(config)#stack
console(config)#movemanagement 1 2

ping

Use the ping command in User EXEC mode to check the accessibility of the desired node on
the network.
Syntax
ping [ ip | ipv6 ]
1074
System Management Commands
fromunit tounit
ipaddress hostname
| [ repeat
count interval
] [ timeout
size
] [ size ]