Table of Contents
Advertisement
show ip route
show ip route [static]
Description
View the Dellcontroller routing table.
Syntax
Command
static
Usage Guidelines
This command displays static routes configured on the controller via the
gateway
command to set the default gateway to the IP address of the interface on the upstream router or switch to
which you connect the controller.
Examples
The example below shows the ip address of routers and the VLANs to which they are connected.
(host) #show ip route
Codes: C - connected, O - OSPF, R - RIP, S - static
M - mgmt, U - route usable, * - candidate default
Gateway of last resort is 10.6.2.254 to network 0.0.0.0
S*
0.0.0.0/0
C
10.9.2.0 is directly connected, VLAN1
C
10.9.3.0 is directly connected, VLAN63
C
10.9.4.0 is directly connected, VLAN64
C
10.9.5.0 is directly connected, VLAN65
C
10.9.6.0 is directly connected, VLAN66
C
0.0.0.0 is directly connected, Tunnel 1
C
10.100.103.253 is an ipsec map default-local-master-ipsecmap
Related Commands
Command
ip radius
Command History
Introduced in ArubaOS 3.0.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Include this optional parameter to display only static routes.
[1/0] via 10.6.2.254*
Description
This command configures global parameters for configured RADIUS servers.
ip route
command. Use the
ip default-
show ip route | 1085
Advertisement
Table of Contents
