Network Monitoring Commands - D-Link DGS-3212SR Command Line Interface Reference Manual

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
show packet ports
show error ports
show utilization
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
N
Parameters
<portlist>
<portlist>
[cpu | unit_id <int>]
ports <portlist>
index <value>
<index 1-4> ipaddress <ipaddr>
{severity[informational|warning|all] |
facility[local0|local1|local2|local3|local4|local5|local6|local7] |
udp_port <udp_port_number> | state [enable|disable]}
{host [all|<index 1-4>]} { severity[informational|warning|all] |
facility[local0|local1|local2|local3|local4|local5|local6|local7] |
udp_port <udp_port_number> | ipaddress <ipaddr> | state
[enable|disable]}
[<index 1-4 | all > ]
[<index 1-4>]
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to display statistics about the packets sent and received by
the switch.
show packet ports <portlist>
This command is used to display statistics about packets sent and
received by ports specified in the port list.
<portlist> − Specifies a range of ports to be displayed. The port list
is specified by listing the lowest switch number and the beginning
M
ETWORK ONITORING
59
9
C
OMMANDS