Remote Network Monitoring (Rmon) Commands - D-Link DGS-510 Reference Manual

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
57. Remote Network MONitoring (RMON)
Commands
57-1 rmon collection stats
This command is used to enable RMON statistics on the configured interface. Use the no form of this
command to disable the RMON statistics.
rmon collection stats INDEX [owner NAME]
no rmon collection stats INDEX
Parameters
INDEX
owner NAME
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The RMON statistics group entry number is dynamic. Only the interface that is enabled for RMON
statistics will have a corresponding entry in the table.
Example
This example shows how to configure an RMON statistics entry with an index of 65 and the owner
name "guest" on Ethernet interface eth3/0/2.
Switch# configure terminal
Switch(config)# interface eth3/0/2
Switch(config-if)# rmon collection stats 65 owner guest
Switch(config-if)#
57-2 rmon collection history
This command is used to enable RMON MIB history statistics gathering on the configured interface.
Use the no form of this command to disable history statistics gathering on the interface.
rmon collection history INDEX [owner NAME] [buckets NUM] [interval SECONDS]
no rmon collection history INDEX
Parameters
INDEX
Specifies the Remote Network Monitoring (RMON) table index. The
range is from 1 to 65535.
Specifies the owner string. The maximum length is 127.
Specifies the history group table index. The range is from 1 to
65535.
530