Show Ip Isis Interface - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip isis interface

Displays the IS-IS interface information.
show ip isis interface [interface_name] [detail]
Syntax Definitions
interface_name
detail
Defaults
By default the interface information for all the interfaces is displayed.
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
Use the interface_name parameter with this command to view information for a specific interface.
Examples
-> show ip isis interface
=========================================================================
ISIS Interfaces
===============================================================================
Interface Level
-------------------------------------------------------------------------------
system L1L2
if2/1 L2
if2/2 L1
if2/3 L1
if2/4 L1
if2/5 L2
lag-1 L2
if2/8 L2
-------------------------------------------------------------------------------
Interfaces : 8
output definitions
Interface
Level
CircID
Oper-state
Admin-state
L1/L2 -Metric
Interfaces
page 24-80
The name of the interface.
Indicates that the output is displayed in a detailed manner.
CircID Oper-state
1 Up
8 Up
5 Up
6 Up
7 Up
2 Up
3 Up
4 Up
The name of the IS-IS interface.
The level capability of the interface.
The circuit ID of the interface.
The operational state of the interface (up or down).
The administrative state of the interface (up or down).
The metric value of the router for the corresponding capability level.
The total number of interfaces.
Admin-state L1/L2-Metric
Up 10/10
Up - /10
Up 10/-
Up 10/-
Up 10/-
Up -/10
Up -/10
Up -/10
OmniSwitch CLI Reference Guide
IS-IS Commands
June 2012