IS-IS Commands
ip isis interface level passive
Configures the interface as passive at the specified IS-IS level.
ip isis interface interface_name level [1 | 2] passive
no ip isis interface interface_name level [1 | 2] passive
Syntax Definitions
interface_name
1
2
Defaults
By default, the interface level passive configuration is disabled.
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove the passive attribute.
•
The passive interface will not permit ingressing and egressing IS-IS PDUs.
Examples
-> ip isis interface lan-5 level 1 passive
-> no ip isis interface wan-10 level 1 passive
Release History
Release 6.2.1; command was introduced.
Related Commands
ip isis interface passive
show ip isis interface
MIB Objects
vRtrIsisIfLevelTable
vRtrIsisIfLevelPassive
OmniSwitch CLI Reference Guide
The name of the interface.
Specifies the IS-IS level as Level-1.
Specifies the IS-IS level as Level-2.
Configures the interface as passive.
Displays the IS-IS interface information.
June 2012
page 24-77