Ip Isis Interface Level-Capability - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip isis interface level-capability

Configures the IS-IS level on the specified interface.
ip isis interface interface_name level-capability [level-1 | level-2 | level-1/2]
Syntax Definitions
interface_name
level-1
level-2
level-1/2
Defaults
parameter
level-1 | level-2 | level-1/2
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
Changing the level capability restarts the IS-IS protocol on the interface.
•
If the level capability is configured globally and on a specific interface, the combination of the two
settings will decide the potential adjacency.
Examples
-> ip isis interface vlan-101 level-capability level-1
Release History
Release 6.2.1; command was introduced.
Related Commands
ip isis level-capability
show ip isis interface
MIB Objects
isisCircTable
isisCircLevel
page 24-66
The name of the interface.
Specifies that the interface can operate at Level-1 only.
Specifies that the interface can operate at Level-2 only.
Specifies that the interface can operate at both Level-1 and Level-2.
default
level-1/2
Configures the router level of the IS-IS protocol globally.
Displays the IS-IS interface information.
OmniSwitch CLI Reference Guide
IS-IS Commands
June 2012