Adjusting Reel Speed - MacDon M2170NT Operator's Manual

12. On the side of the machine that is higher, remove nut,
washer, and bolt (A) that attaches shims (B) to the linkage.
13. Remove one or both of shims (B) and reinstall
hardware (A).
14. Repeat Step 4, page 254
cylinders and check the header level.
15. If additional adjustment is required, repeat Step
254 to Step 12, page 255, and install one of the removed
shims on the opposite linkage.
16. Reset the header float. For instructions, refer to
NOTE:
Additional shims are available from your Dealer.

5.5.6 Adjusting Reel Speed

Reel speed is displayed in either rpm, mph, or km/h (depending on the global units selection). The default reel speed is
60 rpm and can be set to auto or manual mode.
• AUTO mode: Minimum reel speed and operating reel speed differential relative to ground speed are set, and the reel
speed is maintained. For instructions, refer to
• MANUAL mode: Reel speed is set and maintained regardless of ground speed. For instructions, refer to
Speed in Manual Mode, page
NOTE:
Both speed modes work with the One-Touch-Return feature. For example, button A on the ground sped lever (GSL) can be
set for MANUAL mode and button B can be set for AUTO mode. For instructions, refer to
80.
262171
to Step 8, page 254 to rephase the
9, page
Setting Float, page
Setting Reel Speed in Auto Mode, page
257.
OPERATION
A
B
Figure 5.128: Lift Linkage Shims
238.
255
256.
Setting Reel
One-Touch-Return Buttons, page
Revision A