Table of Contents
Advertisement
24. Proceed as follows:
• If you are attaching the header to an M2170 Windrower:
and Electrical Components – M2170 Windrower, page 169
• If you are attaching the header to an M2260 Windrower:
and Electrical Systems – M2260 Windrower, page 174
5.4.3 Connecting R2 Series Rotary Disc Header Hydraulic and Electrical Components
– M2170 Windrower
Connecting the header hydraulic and electrical systems to the windrower involves attaching the header's knife drive,
pressure, return, case drain, and electrical connectors to the windrower's receptacles.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
CAUTION
Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all (fixed and
movable) hydraulic couplers.
1. Shut down the engine, and remove the key from the ignition.
2. Approach platform (A) on the left side of the windrower.
Ensure that the cab door is closed.
3. Push latch (B) and pull platform (A) toward the walking
beam until it stops and the latch engages.
262175
ATTACHING HEADERS TO WINDROWER
5.4.3 Connecting R2 Series Rotary Disc Header Hydraulic
5.4.4 Connecting R2 Series Rotary Disc Header Hydraulic
169
A
Figure 5.159: Left Platform
B
1015479
Revision A
Advertisement
Table of Contents
