Chapter 6: Attaching Hydraulic And Electrical Components; Connecting Header Hydraulic And Electrical Systems - M2170 Windrower - MacDon R113 Unloading And Assembly Instructions

Chapter 6: Attaching Hydraulic and Electrical Components

The procedure for attaching the header hydraulic and electrical components depends on the windrower model.
NOTE:
Hydraulic conversion kits are needed to convert a header configured for operating with an M1 or an M2 Series Windrower
so that it can work with an M Series Windrower
Refer to the relevant hydraulic and electrical attachment procedure:
• 6.1 Connecting Header Hydraulic and Electrical Systems – M2170 Windrower, page 63
• 6.2 Connecting Header Hydraulic and Electrical Systems – M2260 Windrower, page 67
• 6.3 Connecting Header Hydraulic and Electrical Systems – M1240 Windrower, page 83
• 6.4 Connecting Header Hydraulic and Electrical Systems – M1170 Windrower, page 89
• 6.5 Connecting Header Hydraulic and Electrical Systems – M155 or M155E4 Windrowers, page 94
• 6.6 Connecting Header Hydraulic and Electrical Systems – M205 Windrower, page 101
6.1 Connecting Header Hydraulic and Electrical Systems – M2170
Windrower
The header's hydraulic and electrical multicoupler will need to be connected to the windrower.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
CAUTION
Do NOT stand on an unlocked platform. It is unstable and may cause you to fall.
IMPORTANT:
To prevent contamination of the hydraulic system, use a clean rag to remove dirt and moisture from all (fixed and
movable) hydraulic couplers.
1. Shut down the engine, and remove the key from the ignition.
2. Retrieve the hydraulic hoses from the header.
2. The R113 SP is compatible with the M155, M155E4, and M205, but not with the M100, M105, M150, and M200.
262300
2 , and vice versa. Contact your MacDon Dealer for more information.
63
Revision A