Attaching R1 Series Sp Disc Header To M155E4 Windrower: Self-Aligning Hydraulic Center-Link - MacDon R113 Operator's Manual

14. Disengage safety prop by turning lever (A) downward to
raise safety prop until lever locks into vertical position.
NOTE:
If safety prop will not disengage, raise header slightly.
15. Repeat for opposite side.
CAUTION
Check to be sure all bystanders have cleared the area.
16. Start engine and press HEADER DOWN switch (A) on
GSL to fully lower header.
NOTE:
If not prompted by the HPT display to restore float,
restore float manually.
17. Stop the engine and remove the key.
18. Proceed to 3.5.4 Attaching Hydraulics and Electrical
Connections, page 42.
3.5.2 Attaching R1 Series SP Disc Header to M155E4 Windrower:
Self-Aligning Hydraulic Center-Link
1. Remove hairpin (B) from clevis pin (A) and remove
clevis pin from the header supports (C) on both sides of
the header.
214077
OPERATION
Figure 3.20: Cylinder Safety Prop
A
Figure 3.21: Ground Speed Lever
Figure 3.22: Header Support
32
A
C
B
A
Revision A