New Holland T8010 Manual page 1651

STEP 3
The display will read CONFIG ICU with options,
Operator Setup, Controller Config and Exit. The
default will highlight Operator Setup. Press the
PROG key.
STEP 4
The display will read CONFIG ICU with the operator
setup options, Unit, Tire Radius, Radar Cal, Old
Hours and Exit. The default will highlight Unit. Press
the PROG key.
Section 55 - Electrical System, Controller - Chapter 6
MD05F005
MD05F006
STEP 5
The display will show under the UNIT heading
English and Metric. The last stored heading will be
highlighted. The default setting is English. Display
units can now be selected, either English or Metric,
by using the INCR or DECR keys. Press the PROG
key to save your choice. The display will return to the
operator setup options.
STEP 6
Use the INCR or DECR keys to highlight Tire
Radius. Press the PROG key.
55-6-6
MD05F007
MD05F009